Videofied Indoor Light Commercial / Residential Panel

The Control Panel Model XL GPRS is a wireless, battery operated security system control panel for the Videofied integrated alarm and video verification system. The control panel is designed for residential and small commercial security applications where video verification is needed or desired.

The control panel is powered by eight 1.5-volt alkaline batteries that last up to four years, with normal system activity. A built-in siren provides status beeps. The embedded cell modem communicator reports to the monitoring station and and enables 2-way voice communication over cell to the monitoring station.

A dual-tamper function is active 24 hours, whether or not the system is armed. An alarm occurs if the control panel cover is removed, or if the control panel is removed from the mounting surface.

With the embedded touchpad the user can arm, disarm the system and review past events and system status. Under the TouchPad an integrated proximity card reader that can be used to arm and disarm the system without using the TouchPad. The proximity card/tag arming system is designed to maximize operator convenience.

Supervised Wireless Technology

The XL GPRS, along with all devices utilize patented S2View® - Spread Spectrum, Interactive, AES Encrypted Wireless technology, providing optimum signal integrity and security. Bi-directional RF communication paths between all system devices and the system control panel assure high signal reliability. Integrated antennas eliminate protruding wires or rods cumbersome to install and unsightly to consumers, and if damaged could lead to potential system communication problems.

The panel supervises every device (excluding the remote keyfob) to validate current open/close state, tamper condition, serial number, date of manufacture, firmware revision, and battery status..

Features

• S2View® - Spread Spectrum, Interactive AES Encrypted Wireless technology provides optimum signal integrity and security.
• Compatibility - works with all wireless devices.
• Supervision of all devices (except remote keyfob).
• Tamper detection - 24-hour dual-tamper function provides detection for both cover and wall removal. Control panel also monitors all system device tamper switches.
• Zones / Devices - 19 maximum.
• Areas - 4 maximum. Area 1 predefined from factory for entry/exit delay. Areas 2, 3, and 4 can be configured as needed.
• Access codes - 20 maximum, 4 - 6 digits; one installer access code for on-site programming only.
• Configuration/Programming - on-site using alphanumeric keypads or off-site using Frontel control remote Software.
• Communication - reports to central monitoring stations using Frontel.
• Video Verification - video resolution of 320 x 240 pixels, 0 lux sensitivity, 5-frames per second for approx. 10 seconds total recording time. 220K MPEG file.
• History/Event Log - maximum 4,000 events stored in flash memory that cannot be cleared or erased.